Product Overview:

At present, the state metal ore body in the deep mining state, so the ore hardness is very large. In order to solve the problem, I plant the latest design success of a dedicated consumption of hard ore conical wet mill.

The main features of this cone-shaped wet mill are: to increase the weight of the roller at the same time, reduce the force area, after the rotation of the wheel, so that the pressure of the pressure ore increased to achieve the purpose of production (yield 24 hours Less than 150 tons).

On the basis of the original equipment, but also to increase a set of scraper device, mainly to keep the material layer is always 4-5 cm, only in this state, the best pressure material. And, the material can quickly clean up the grinding groove.

Product structure and principle:

The main grinding machine (diesel engine) will drive the power to the reducer, driven by the reducer, through the large-scale grinding machine, The vertical axis transmits the torque to the abscissa above, and then transmits the rods at both ends of the abscissa to the grinding wheel, causing the pulley to generate a driving force and to rotate counterclockwise in the horizontal direction of the horizontal axis. The grinding wheel at work Wet grinding machine large shaft rotation, but also around the center wheel of the wheel rotation, grinding plate is fixed. It is widely used in a variety of pulse gold, rock gold, sand gold, associated gold mine grinding operations, the application of a wide range of minerals (natural gold, fissure gold, wrapped gold, fine gold, fine grain gold) Can achieve a good grinding indicators for the follow-up gold operations, to provide favorable conditions; grinding efficiency, crushing ratio, 80-200 mesh ratio of up to 95%, the machine assembly of new WS horizontal reducer, Grinding wheel, roller with special casting parts, Seiko design, durable, with low noise, low loss, less investment, quick and so on. Is the majority of small selection of gold mine the preferred mining equipment.

The factory after years of practice based on user feedback information, in the Beijing Mining Machinery Design Institute experts to help, is to develop a new type of wet mill. Casting with manganese steel liner life greatly improved, the output can be increased by 30% -60%, due to the use of small pieces of the docking docking installation, so that the replacement does not require large-scale lifting equipment, not affected by the venue, reducing production costs. Equipped with a motor less than 30% of the traditional wet mill motor and manufacturers can be equipped with soft-start equipment, rack design: square steel welding, channel connection, the use of thickened steel plate, the normal use of the machine is no longer delay production The

Gearbox compared with the traditional gearbox has changed a lot, a shaft with 500 loader assembly principle to install, so that the use of a cycle greatly increased several times. Improved, the device through the user to use, consistent response is very good, to solve the user's worries, and through the authority of the department's detection.

For a variety of mineral grinding parts, can achieve the same grinding effect with the ball mill, grinding costs far below the ball mill, is a small energy-saving grinding equipment. Product Application:

The machine features: investment can be small or small. Small capital, can be a single type of mineral processing, large capital, group group beneficiation. For example, a group of 2, 4, 8, 12 can be produced. In short, regardless of the ball mill or grinding machine, are to achieve the purpose of the ore to achieve the purpose of the ore, in addition, I plant production roller is used in the ring type, the use of a year later, for the roller when only for the outside Of the circle on the line, grinding roller, grinding the end is to use pure white iron to join the special wear-resistant materials processing, durable.

In the process of selecting gold (gold ore and rock), we should fully follow the principle of "more broken and less grinding": use the crusher as much as possible to reduce the particle size of the material and reduce the comprehensive grain size of the raw material, Machine work efficiency, reduce the overall loss of the concentrator.

Product specifications and technical parameters:

model